Pitney Bowes Relay 5000, Operator'S Manual, Page: 70 / 202

3-26 SV63136 Rev. A
3 • Basic Operation
SwiftStart
™
Jobs
SwiftStart
™
mode allows you to run a simple job without entering any setup
information. In SwiftStart
™
mode, the system automatically senses the mate-
rial and sets the required parameters for running the job. A SwiftStart
™
job
can be run without saving the settings, or a Supervisor/Manager can name
and save the job for future recall and use.
Use SwiftStart
™
when your mail piece consists of only a small number of
sheets of one size that can be folded.
• A single sheet and a single insert will be taken from each loaded feeder,
giving a maximum mail piece content of: four sheets and three inserts
(Relay 50000/6000) or four sheets and four inserts (Relay 7000/8000).
Fold will be determined by sheet length and envelope depth.
NOTE: The maximum content options are available only when two HCSFs
are present.
• Maximum sheet length is 11-5/8 inches (297mm)
• Only envelope depths of 4-1/4inches to 6-3/8 inches (109mm, 111mm,
114mm, 121mm and 162mm) can be used.
• Cannot be used to run fold only or inserts only.
• Cannot link feeders in this mode.
• Envelope sealer is always on (except on trial piece).
• Batch count is always off.
• This mode will not work with scanning.
• Address should be at the top of the sheet.
Starting the Job
When your Trial Piece is verified, you are ready to start running the job. To
do this:
1. Make sure that you are in the Home screen.
2. Press
START . The system will begin running the job.