Paradyne JetFusion 2208, User Manual

Page: 69 / 247

C o n f i g u r a t i o n 4-13
Select Individual Channels
1
Type
“3”
to enable or disable specific channels. If all channels are
disabled, this option enables specific channels. Conversely, if all channels
are enabled, this option disables specific channels.The IAD displays
prompts you to select Channel Enable/Disable.
2
For each channel, type the number and press Enter. When you have entered
all channels to enable or disable, press Enter. The IAD saves the
configuration and displays the T1 Configuration menu.
3
Continue with other configuration tasks.
Select Channel Range
To select Channel Range, perform the following steps:
1
Type
“4”
to enable a range of channels. The IAD displays the channel
status and prompts you to select a Channel Range and to type in the
Beginning Channel.
2
Type the beginning channel and press Enter. The IAD prompts you to type
in the Last Channel of Range.
3
Type the ending channel to enable and press Enter. The IAD makes the
change and saves the configuration and displays the T1 Configuration
menu.
4
Continue with other configuration tasks.
Configure Transmit
Clock Source
To Configure the Transmit Clock Source, follow the steps below.
1
Type
“8”
on the T1 Configuration menu to select Configure Transmit
Clock Source, which will display the Select Tx Clock Source menu (Figure
4.14) with a status message.
Figure 4.14
Select Tx Clock Source Menu
2
Type
“1”
to select External or Slave mode, or type
“2”
to select Internal
or Master mode. The IAD saves the configuration and resets the interface.
3
Press Escape to return to the T1 Configuration menu and continue with
other configuration tasks.
4
After you reset the IAD, you will see a prompt to type
“1”
to select
External or
“2”
to select Internal mode. Enter your selection.
The IAD saves the configuration and resets the interface.