Paradyne JetFusion 2208, User Manual

Page: 125 / 247

C o n f i g u r a t i o n 4-69
Configure SIP
Parameters
To Configure SIP parameters, follow the steps below.
1
Type
“C”
on the SIP Management menu (Figure 4.73) to set the Transmit
and Receive parameters for SIP.
2
Enter the DNS name or IP address for the SIP proxy
( siptest.somewhere.com , for example, including the dotted IP address or the
FQDN of a SIP proxy). The currently configured proxy is displayed in the
brackets. After typing the text, press Enter.
3
The IAD prompts you for the line prefix, which is part of an endpoint
(phone line) name common to all endpoints on the IAD. Endpoints are
named in the following manner: line_prefixXX, where XX is the endpoint
number. For example, the prefix blackphone will produce names
blackphone01 and blackphone02 on an IAD using the first two phone lines.
After typing the text (or to keep the line unmodified), press Enter.
4
The IAD prompts you for a password, which is required to authenticate the
proxy. After typing the text (or to keep the line unmodified), press Enter.
5
The IAD will display the SIP signaling parameters, and you may configure
the VPI/VCI. This interface/own IP address is used to send/receive SIP
signaling packets and is the same interface/port/connection configured
elsewhere in the IAD.
6
Enter the starting RTP to be used for voice transport. This interface/own IP
address is used for RTP voice streams. The starting port number is the port
number used by the first phone line, and the port numbers increment by two
for each line. You may type in a new value and then press Enter, or press
Enter without typing in a new value to retain the old value.
7
The IAD displays the RTP transport parameters. This is the same interface/
port/connection configured elsewhere in the IAD.
8
Enter the TOS byte of the SIP signaling packets [0-7]. You may enter a new
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
9
Enter the TOS byte of the RTP voice streams [0-7]. You may enter a new
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
Display SIP
Parameters
Type
“I”
on the SIP Management menu (Figure 4.73) to display the
configured SIP parameters.
CODEC Selection
Menu
Type
“E”
on the SIP Management menu (Figure 4.73) to select the CODEC
option you wish to use. The default is G.729a. The use of 726 and 729a are
mutually exclusive; the IAD will configure only one or the other.
Display SIP Statistics Type
“S”
on the SIP Management menu (Figure 4.73) to display the endpoint
(line) and connection statistics. If no calls are active, the IAD indicates
whether or not the endpoint is currently connected to its Notified Entity.
If SIP configuration is not correct, the IAD displays a message warning you
that the configuration is invalid and intialization is incomplete.