Paradyne JetFusion 2208, User Manual

Page: 68 / 247

4-12 2 0 0 0 - A 2 - G B 2 1 - 1 0
Figure 4.12 Loopback Configuration Menu
2
Type the option number
“1”
,
“2”
or
“3”
to enable or disable Outward
Payload, Outward Line, and Inward Line Loopback. Inward Loopback is
valid only when the IAD is in Master Mode. The IAD makes the change and
resets the interface.
3
Type
“4”
to enable or disable receipt of ESF loopback commands. (This
option is valid only when Framing Mode is set to ESF). The IAD saves the
changes and redisplays the Select Loopback Configuration menu.
4
Press Escape to return to the T1 Configuration menu and continue with
other configuration tasks.
Configure Transmit
and Receive Channels
To configure Transmit and Receive Channels, follow the steps below.
1
Type
“6”
on the T1 Configuration menu (Figure 4.9) to select Configure
Transmit Channels, or
“7”
to select Configure Receive Channels. The
IAD displays a message indicating the number of channels enabled, and
displays the Channel Configuration menu (Figure 4.13).
Figure 4.13 Channel Configuration Menu
Each option on this menu is described in detail below.
Enable or Disable All Channels
Type
“1”
to enable all channels, or type
“2”
to disable all channels. The
IAD makes the change and resets the interface. (The menu and reset messages
may conflict; press any key to refresh the menu.)