103
Camera Settings
Section 5-2
Note
The default setting is marked with an asterisk.
1.
Enter System mode and select Camera settings.
SeeAlso
Refer to page 102.
The Camera Settings Screen will be displayed.
2.
Select the model of the connected Camera.
3.
If using Intelligent Lighting, select the model.
4.
Select End.
The settings will be registered and the System Settings Screen will return.
CHECK
If Other is selected under Camera, the Camera Settings (Detail) Screen
will be displayed.
The settings for F200/F300 Cameras are listed in the Setup Manual. Refer
to the Setup Manual.
Precaution
When changing the Camera model, save settings data in flash memory.
Set the measurement conditions after starting the F160 again.
Intelligent
Lighting 0
Out of use*
LTC20
LTC50
If a Camera with Intelligent Lighting is connected,
select the model of the Intelligent Lighting.
Always set the DIP switch on the Intelligent Lighting
to 0, regardless of the Camera number.
Refer to the Setup Manual.
Intelligent
Lighting 1
Out of use*
Only one Camera can be used with the Conversa-
tional Menus so this menu item must be set to Out of
use.
Menu item
Models
Details
Camera settings
Camera :
F160-S1
Intelligent Lighting 0 :
Out of use
Intelligent Lighting 1 :
Out of use
End
Camera settings(Detail)
Camera Speed
Shutter
Syncronization
Strobe disable, start
Strobe disable, end
Clamp pulse timing
[ 90]CLK
Clamp pulse width
↑
↓
:
:
:
:
:
Normal
SYNC RESET
External
End
[ 0]H
[ 0]H
[ 25]CLK
:
:
Summary of Contents for F160 Vision Sensor
