55
Position
Section 3-3
The screen for specifying the inspection position will be displayed.
5.
Use the Up/Down and Left/Right Keys to move the cursor to the position
to be inspected. This specifies the inspection position.
SHIFT + Up/Down or Left/Right Keys: Move the cursor quickly.
SHIFT + ESC Keys: Used to correct the position. Returns to the
screen for aligning the coordinate axis.
ENT: Sets the position.
A screen giving the option to specify a reference position will be displayed.
6.
Select Yes to specify a relationship between the inspection point and a
particular point on the workpiece.
Select No if no particular relationship is to be specified.
If Yes is Selected
Any point can be specified as the reference point. The relationship be-
tween the two points is found when inspection is performed. Go to step (7.)
If No is Selected
The origin will become the reference point. Go to step (9.)
0.Scn 0 =SET= Region
S+ESC:Adjust coordinates
↑
↓←→
: Move ENT:Set ESC: Back
0.Position
Set position
to inspect.
X=359.712
Y=292.826
No
Back
Yes
Do you want to specify
the reference position?
+
+
Reference position
+
+
Origin
Summary of Contents for F160 Vision Sensor
