Omron F160 Vision Sensor, Operation Manual, Page: 123 / 148

114
Setting Conditions for Saving Measurement Images
Section 5-5
Switching Method
In Monitor Mode or Run Mode, press the SHIFT + Up/Down Keys to switch
between images.
5-5-2 Clearing All Stored Images
All images are automatically cleared when the power is turned OFF, but the
images can also be cleared without turning OFF the power.
Display
Details
The image that has just been measured is displayed. Whether
this image is a freeze image or a through image depends on the
settings in SYS/Conditions.
A previously stored image is displayed.
Up to 35 images are stored in accordance with the conditions for
storage of measured images (only NG or All). When the image is
to be backed up to a personal computer, specify a memory
number in
@ .
The measured image most recently stored is displayed. If this
image had an NG judgement, "Last" will be highlighted.
The * after "Last" contains the number of screens stored before
the image. Up to 35 previous images can be displayed. "Last *"
will be highlighted for NG images.
Either no image is stored in memory, or an image other than a
measurement image (an image loaded from a personal computer)
Refer to page 104.
Last
Types of saved images
Last *
-----
(Memory
@
)
Note 1
Note 2
Last 35 (Mem
@
)
Last 34 (Mem @ )
Last 1 (Mem @ )
Last (Mem
@
)
Freeze or through image
Last 2 (Mem @ )
Last * (Mem @ )
If the following conditions hold, the
number of stored images will not
exceed 34.
· Image storage: Set to only NG
· Last measurement was OK.
The image display status changes
depending on the settings under
SYS/Conditions.
+
SHIFT
+
SHIFT
+
SHIFT
+
SHIFT
+
SHIFT
+
SHIFT