Omron F160 Vision Sensor, Operation Manual, Page: 71 / 148

62
Chips and Burs
Section 3-5
3-5 Chips and Burs
Chip and bur inspections check for chips and burs on the circumference of
workpieces.
SeeAlso
Refer to page 3 Inspection Types.
The settings operation is shown in the following diagram. Only the outline will
be given here. Follow the instructions given by the operational guide on the
Monitor screen.
3-5-1 Selecting Chips and Burs
Select Chip/Bur on the screen for selecting inspection types.
3-5-2 Specifying Inspection Regions
1. Select and draw a figure suitable for the inspection region and press the
ENT Key to set the region.
SeeAlso
Refer to page 18 for details on drawing figures.
2. Follow the instructions provided by the on-screen operational guide to
make the rest of the settings.
Set inspection details.
2
Add
End
Return to
screen to
select type
of inspection.
Add
inspection
details.
2.
Specify
points to
inspect.
1.
Select
Chip/Bur
1
STEP
4
0.Scn 0 =SET= Region
Select the type of
inspection.
(Up to 32 regions)
S+ENT:Help S+
←→
:Switch display
Start
Ref image
>>Region
Position
End
Presence
Orient'n
Dimens'n
Surface
Conform
Position
Chip/Bur
Back
0.Scn 0 =SET= Region
ESC:Back
Enclose the area to
be inspected.
0.Chip/Bur
Line
Circum
Arc