![background image](http://html1.mh-extra.com/html/omron/f160-vision-sensor/f160-vision-sensor_operation-manual_741258088.webp)
79
Backing Up Data
Section 4-3
The default communications settings are as shown in the following table.
These settings can Normally be used.
Note Both XMODEM and ZMODEM transfer protocols are supported.
Use the protocol that matches the computer settings.
3.
Start the Hyper Terminal program on the computer and make the following
communications settings. The same communications settings must be
used on both the F160 and the modem on the computer.
Note XMODEM or ZMODEM protocol is used, so flow control is not per-
formed.
4.
Once the communications settings have been made on the computer, dis-
play the Basic Screen for Monitor Mode or Run Mode.
5.
Move the cursor to MON (or RUN) and press the ENT Key.
The mode selections will be displayed.
6.
Select TOOL.
Item
Setting
Communications protocol RS-232C
Baud rate
38,400 (bps)
Data length
8 (bits)
Parity bits
None
Stop bits
1 (bit)
Protocol
XMODEM
(See note.)
Item
Setting
Baud rate
38,400 (bps)
Data length
8 (bits)
Parity bits
None
Stop bits
1 (bit)
Flow control
None (See note.)
Freeze
---- ---ms
0.Scn 0
MON
STEP/TRG:Msr S+
↑
↓
:Mem img
S+ENT:Help S+
→
:Adjust
S+ESC:Set disp
---- ---ms
0.Scn 0
MON
SET
MON
RUN
SYS
TOOL
SAVE
Summary of Contents for F160 Vision Sensor
