Omron F160 Vision Sensor, Operation Manual, Page: 80 / 148

71
Changing Scenes and Scene Groups
Section 4-2
If Yes was selected, the Position Compensation Screen will be displayed.
SeeAlso
Refer to page 18 for details on drawing figures.
2. Follow the instructions provided by the on-screen operational guide to
make the rest of the settings.
CHECK
After the settings have been changed, be sure to save them to flash mem-
ory before turning OFF the power. If the power is turned OFF without sav-
ing new settings, all of the setting changes will be lost. (Refer to page 86.)
4-2 Changing Scenes and Scene Groups
The different situations (types of measurement object and types of measure-
ments required) in which measurements are performed are called “scenes”
and the measurement conditions set in Set Mode are called “scene data.” The
scene function can be used to set 32 types of measurement conditions. If
detection conditions change, simply switch scenes to change to a different
measurement setup.
The normal limit of 32 scenes may not be possible for some settings if there is
insufficient memory. A message will appear on the screen if there is insuffi-
cient memory. Make the region smaller or delete unnecessary regions or mod-
els.
CHECK
Up to 1,024 scenes can be stored if a 128-Mbyte Memory Card is inserted. Up
to 32 scenes make up a scene group and up to 32 scene groups can be set,
i.e., 32 scenes x 32 scene groups = 1,024.
↑ ↓←→
: Move ENT:Set ESC: Back
0.Scn 0 =SET= Position
Enclose mark, hole,
corner, etc., that will be on
every workpiece (2 positions)
100,100