Oce Arizona 550 GT, User Manual

Page: 122 / 263

B: Cut the Media
1.
Click on the Roll Manager icon to bring up the Roll Media Manager.
2.
Select the Unload icon in the Roll Media Manager to release the tension on the media
so it can be cut.
3.
Cut the media with a blade along the cut guide.
4.
Click on OK to proceed.
C: Remove Media from the Take-up Shaft in Printer or Remove Take-up Shaft
1.
If there are only a few images on the take-up roll and you want to remove them without
removing the take-up roll from the printer you can press the left pedal to rotate the take-
up media shaft in the reverse direction. You can then roll up the media by hand as comes
off the take-up roll.
2.
The other option is remove the take-up roll from the printer and then remove the roll of
unused media from the media shaft. To remove the take-up roll, tap the right pedal mo-
mentarily to rotate the take-up shaft one revolution to the unlocked position in the forward
direction.
D: Remove the Supply Shaft From the Printer
1.
If you want to change the supply shaft, momentarily press the left pedal to rotate the
supply shaft four complete revolutions. This rewinds excess media back onto the supply
roll if is not empty) to the unlocked position.
2.
Remove the supply shaft from the printer by pulling it up and out of the drive coupler.
E: Remove Media Roll Or Empty Core From the Media Shaft
1.
Place the media shaft on a suitable work surface.
2. Unlock the media shaft core locks using a 5 mm hex key.
3.
Slide the media core off the shaft.
Result
Roll Media unit is now ready for you to load new media.
Chapter 6 - How to Operate the Roll Media Option 122
How to Unload and Cut Media