NEC UNIVERGE SL2100, Programming Manual

Page: 89 / 678

Dial Types Dial Type Descrip-
tion
Related Program Note
1 Service Code 11-10 : Service Code Setup (for System Administrator) on
page 2-75
11-11 : Service Code Setup (for Setup/Entry Operation) on
page 2-78
11-12 : Service Code Setup (for Service Access) on page 2-82
11-14 : Service Code Setup (for Hotel) on page 2-88
11-15 : Service Code Setup, Administrative (for Special Access)
on page 2-90
11-16 : Single Digit Service Code Setup on page 2-92
2 Extension Number 11-02 : Extension Numbering on page 2-70
11-04 : Virtual Extension Numbering on page 2-71
11-07 : Department Group Pilot Numbers on page 2-72
3 Trunk Access Code 11-09-01 : Trunk Access Code
4 Special Trunk Access 11-09-02 : Trunk Access Code
5 Operator Access 20-17 : Operator Extension on page 2-210
6 F-Route Access 44-xx
8 Networking Access
(Network ID : 0 ~ 50)
9 Dial Extension Ana-
lyze 11-20 : Dial Extension Analyze Table on page 2-95
Changing the Dial Type for a range of codes can have a dramatic affect on how your system operates.
Assume, for example, the site is a hotel that has room numbers from 100 ~ 399. To make extension numbers
correspond to room numbers, you should use Program 11-02 to reassign extension numbers on each floor
from 100 to 399. (Other applications might also require you to change entries in Program 11-10 ~ 11-16.)
Default
See the following tables for default settings.
Table 2-2 System Numbering Default Settings
Dial Types : 1 = Service Code, 2 = Extension Number, 3 = Trunk Access, 4 = Special Trunk Access, 5 =
Operator Access, 6 = Flexible Routing, 8 = Networking Access, 9 = Dial Extension Analyze, 0 = Not Used
Dialed Number of Digits Required Dial Type
Default New Default New
1X 3 2
11 0 0
12 0 0
13 0 0
14 0 0
15 0 0
16 0 0
17 0 0
18 0 0
19 0 0
10 0 0
1
*
0 0
1# 0 0
ISSUE 2.0 SL2100
Programming Manual 2-65
Program
11