NEC UNIVERGE SL2100, Programming Manual

Page: 289 / 678

Item
No.
Item Table Input Data Default
07 Deny Restriction Table
This option lets you program the Restrict
Code Tables.
If the system has Toll Restriction enabled,
users cannot dial numbers listed in these ta-
bles.
There are four Restrict Code Tables, with up
to 60 entries in each table.
The system restricts calls exactly as you en-
ter the code.
[caption: table]
1 ~ 4 (table)
1 ~ 60 (Entry)
Dial (Up to 12 dig-
its) Tables 1 ~ 4 = No Setting
08 PBX Access Code
Use this option to enter the PBX Access
Code.
When the system is behind a PBX, this is the
code users dial to access a PBX trunk.
Toll Restriction begins after the PBX access
code.
For PBX trunks (Program 14-04) the system
only Toll Restricts calls that contain the ac-
cess code.
Always program this option when the system
is behind a PBX, even if you don’t want to
use Toll Restriction.
PBX Access Codes can have up to two dig-
its, using 0-9, #,
*
and LINE KEY 1 (don’t
care).
When using Account Codes, do not use an
asterisk in a PBX access code. Otherwise,
after the
*
, the trunk stops sending digits to
the central office.
Entries 1~4 correspond to the 4 PBX Access
Codes.
Each code can have up to two digits.
[caption: table]
1 ~ 4
Dial (Up to two
digits) Tables 1 ~ 4 = No Setting
09 Specific Dial Outgoing Code [caption: table]
1 ~ 20
Dial (Up to eight
digits) Tables 1 ~ 20 = No Set-
ting
10 Outgoing Call Code Setup [caption: table]
1 ~ 20
Dial (Up to four
digits) Tables 1 ~ 20 = No Set-
ting
Conditions
None
Feature Cross Reference
None
ISSUE 2.0 SL2100
Programming Manual 2-265
Program
21