NEC UNIVERGE SL2100, Programming Manual

Page: 321 / 678

Program 22 : Incoming Call Setup
22-11 : DID Translation Table
Level:
SA
Description
Use Program 22-11 : DID Translation Table to specify for each Translation Table entry (1000).
• The digits received by the system (eight maximum)
• The extension the system dials after translation (36 digits maximum)
• The name that should show on the dialed extension display when it rings (12 characters maximum)
• The Transfer Target - 1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer
destination (Program 22-10).
• Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ... When you want to ...
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2 .
3 Enter characters: D-F, d-f, 3 .
4 Enter characters: G-I, g-i, 4 .
5 Enter characters: J-L, j-l, 5 .
6 Enter characters: M-O, m-o, 6 .
7 Enter characters: P-S, p-s, 7 .
8 Enter characters: T-V, t-v, 8 .
9 Enter characters: W-Z, w-z, 9 .
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters:
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right ar-
row soft key instead to accept and/or add a space.)
Clear/Back or DND (2W Digital/IP Multi-
line Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Conversion Table Number 1 ~ 1000
ISSUE 2.0 SL2100
Programming Manual 2-297
Program
22