NEC N8400-086F, User Manual

Page: 63 / 294

Configuring Your Server 4-13
Option Parameter Description Your Setting
Set User
Password Up to eight
alphanumerics Supervisor password controls
access to the setup utility.
When Enter is pressed, the user is
prompted for a password; press
Esc
to abort. Once set, this can be
disabled by setting it to a null string,
or by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Password on
boot [Disabled]
Enabled Disables or enables password entry
on boot.
Fixed disk boot
sector [Normal]
Write Protect Will write protect the boot sector of
the hard drive to prevent viruses
from corrupting the drive under DOS
if set to write protect.
Power Switch
Inhibit
[Disabled]
Enabled
Enables or disables the POWER
switch mask feature. If "Enabled" is
selected, power-off with the POWER
switch becomes unavailable after
OS boot-up. (Forced shut down
feature is always acceptable to the
server. Forced shut down is a
feature to shut down by pressing the
POWER switch for at least four
seconds.)
[ ]: Factory-set
Security Chip Configuration Submenu
Option Parameter Description Your Setting
TPM Support Disabled
[Enabled] Disables or enables TPM feature.
Current TPM
State – Displays the current TPM state.
Change TPM
State [No Change]
Enable & Activate
Deactivate & Disable
Clear Changes TPM state.
(This option can be selected only
when the supervisor password is
set.)
[ ]: Factory-set