NEC N8400-086F, User Manual

Page: 260 / 294

B-42 Installing the Operating System
10.
Click [Test Switch]
→
[Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results]
Even the system are normal, the following mismatch message will appear sometimes.
Please recheck the switching hub (L2) port and nothing problem with the setting ignore
the messages.
– The switch is configured with aggregatedd ports, but the team type does not support
port aggregation. The switch is configured with VLAN tagging, but the team has no
VLANs.
– Change the team type to SLA, reconfigure the switch for link aggregation, or disable
VLAN tagging on the switch.
11.
Reboot the system.
When the system is Windows Server 2003 x64 Editions / Windows Server 2003
IMPORTANT:
„
AFT/ALB setting must be done after LAN Driver and PROSet
install completed.
„
SFT is not supported.
„
Please confirm the port setting of switching hub (L2) matches the
server network adapter Teaming mode.
1.
Open the [Device Manager].
2.
Open [Network adapters]
→
[Intel(R)xxx] properties.
3.
Click [Teaming] tab and check the [Team this adapter with other adapters] check box.
Click [New Team].
4.
Fill the name of the team in [Specify a name for the team] and click [Next].
5.
Include the adapter to the team and click [next].
6.
Select a team type([Adapter Fault Tolerance]/[Adaptive Load Balancing]).
Click [next].
7.
Click [Finish].
8.
Click [TEAM:"Team name"] from [Device manager]
→
[Network adapters] to modify the
team.
Click [Settings] tab and click [Modify Team] button.