NEC ELECTRA ELITE IPK II, Programming Manual, Page: 533 / 617

Document Revision 1 Electra Elite IPK II
2 - 498 Program 81 : Basic Hardware Setup for Trunk
06 Loop Off-Guard Time Selection
Assign loop off-guard time to prevent noise
that could cause the system to be unable to
answer an incoming Tie line.
1~4
(0.5 sec~2.0 sec)
5~15
(3 sec~13 sec)
(0 = No Setting)
4
(2.0 sec)
07 Length of Wink Signal Selection
Specifies the time a wink pulse is sent to
another system.
0~15
(30 ms~480 ms)
5
(180 ms)
08 Length of Delay Signal Selection
Specifies the time a delay pulse is sent to
another system.
1~15
(300 ms~4.5 sec)
(0 = No Setting)
1
(300 ms)
09 Incoming Interdigit Timeout Selection
To specify the time, in seconds, that an
address signal is missing during the
incoming call detection process before an
error tone is returned to the other system.
0 = 8
1~15
(1~15 seconds)
6
(6 seconds)
10 Wink/Delay Signal Detect Timeout
Selection
To specify a maximum time, in seconds, for
receiving an acknowledgment signal from a
distant system before sending a busy tone.
0 = 8
1~15
(1~15 seconds)
7
(7 seconds)
11 Disconnect Recognition Time Selection
Specifies the minimum time before a
disconnected circuit can be accessed
again.
1~15
(0.1~1.5 seconds)
(0 = No Setting)
3
(0.3 second)
12 Automatic Release Signal Detection
Selection
Specifies the signal detection time for
release of a Tie Line after a disconnect
signal is received from the distant CO or
PBX.
1~14
(50~700 ms)
15 = 8
(0 = No Setting)
7
(350 ms)
13 Pause Time Selection 1~15
(500~7500 ms)
7
(7 seconds)
14 Hookflash Time Selection 1 0 = 20 ms
1 = 40 ms
2 = 60 ms
3 = 80 ms
4 = 100 ms
5 = 140 ms
6 = 160 ms
7 = 200 ms
8 = 400 ms
9 = 600 ms
10 = 800 ms
11 = 1.0 seconds
12 = 1.5 seconds
13 = 2.0 seconds
14 = 3.0 seconds
15 = 5.0 seconds
9
(600 ms)