NEC ELECTRA ELITE IPK II, Programming Manual, Page: 220 / 617

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 185
Description
Use Program 20-18 : Service Tone Timer to set the values for the system service
tone timers. Refer to the following chart for a description of each option, its range and
default setting.
Program 20 : System Option Setup
20-18 : Service Tone Timers
Level:
IN
Input Data
Item
No.
Item
Input
Data
Default Description
Related
Program
01 Extension Dial Tone
Time 0~64800
seconds
30 After getting Intercom dial tone,
a keyset user has this interval
to dial the first digit of the
Intercom call.
02 Busy Tone Timer 0~64800
seconds
15
03 Congestion Tone 0~64800
seconds
10 A Busy Tone when system
resources run short. (such as
DTMF receiver resources).
04 Call Waiting Tone
Timer 0~64800
seconds
10 This option sets the interval
between Call Waiting tones.
This timer also sets the interval
between Off-Hook Signaling
alerts.
05 Multiline Confirmation
Tone 0~64800
seconds
10
06 Interval of Call
Waiting Tone 0~64800
seconds
10
07 Intrusion Tone Repeat
Time 0~64800
seconds
0 After a call is interrupted (such
as Barge In, Voice Mail
Conversation Recording, Voice
Over, etc), the system repeats
the Intrusion Tone after this
interval. Normally, you should
enter 0 to disable this interval.
08 Conference Tone
Interval 0~64800
seconds
0
09
Warning Beep Tone
Signaling Interval
0~64800
seconds
60 14-01-18