NEC ELECTRA ELITE IPK II, Programming Manual, Page: 449 / 617

Document Revision 1 Electra Elite IPK II
2 - 414 Program 47 : In-Mail
08 Delay in Dialing Digital Pager Callback
Number
(Pager Dial Delay)
Use this option to set the delay (0~99
seconds) that occurs just before IPK II
In-Mail dials the Digital Pager Callback
Number portion of the Message
Notification callout number for a digital
pager. Set this delay so the pager service
has enough time to connect to the digital
pager before sending the callback
number. Your pager service may be able
to help you determine the best value for
this option (0~99 seconds). By default,
this option is 9 seconds. When placing a
digital pager notification, the system:
Seizes the trunk specified.
Dials the user-entered notification
number (in Message + OP + N).
Waits the 47-01-08: Delay in Dialing
Digital Pager Callback Number interval.
Dials the number entered in 47-01-07:
Digital Pager Callback Number.
The system assumes that the notification
number will complete dialing
approximately 4 seconds after trunk
seizure. This means that, by default, the
Digital Pager Callback Number will be
dialed into the pager service about 13
seconds after trunk seizure.
0~99 (sec) 9 (sec)
09 Wait Between Digital Pager Callout
Attempts
(Notify Pager Intvl)
Use this option to set the minimum time
(1~255 minutes) between
unacknowledged or unanswered digital
pager Message Notification callouts. (A
subscriber acknowledges a digital pager
notification by logging onto their mailbox.)
After this interval expires, IPK II In-Mail
will try the callout again (for up to the
number of times set in 47-01-14:
Number of Callout Attempts).
If the system dials the callout number and
the pager service is busy, it will retry the
number in one minute.
1~255 (min) 15 (min)
Input Data
Item
No.
Item Input Data Default