NEC 78014Y Series, User Manual

Page: 312 / 547

www.DataSheet4U.com
CHAPTER 15 SERIAL INTERFACE CHANNEL 0 (
µ
PD78014 Subseries)
312
Symbol <7> <6> <5> 4 3 2 1 0 Address When Reset R/W
CSIM0 CSIE0 COI WUP CSIM04 CSIM03 CSIM02 CSIM01 CSIM00 FF60H 00H R/W Note 1
R/W CSIM01 CSIM00 Serial Interface Channel 0 Clock Selection
0
×
Input clock to SCK0 pin from off-chip
1 0 8-bit timer register 2 (TM2) output
1 1 Clock specified with bits 0 to 3 of timer clock select register 3 (TCL3)
R/W CSIM CSIM CSIM PM25 P25 PM26 P26 PM27 P27 Operating Start Bit SI0/SB0/P25 SO0/SB1/P26 SCK0/P27
04 03 02 Mode Pin Function Pin Function Pin Function
0
×
3-wire serial I/O mode (Refer to 15.4.2 3-wire serial I/O mode operation)
1 0 SBI mode (Refer to 15.4.3 SBI mode operation)
Note 2 Note 2
2-wire serial MSB P25 SB1 SCK0
1 1 0
× ×
0 0 0 1 I/O mode (CMOS (N-ch open-drain (N-ch open-
input/output) input/output) drain
Note 2 Note 2
SB0 P26 input/output)
1 0 0
× ×
0 1 (N-ch open-drain (CMOS
input/output) input/output)
R/W WUP Wake-up Function Control Note 3
0 Interrupt request signal generation with each serial transfer in any mode
1 Interrupt request signal generation when the address received after bus release (when CMDD = RELD = 1)
matches the slave address register (SVA) data whenthe SBI mode is used
R COI Slave Address Comparison Result Flag Note 4
0 Slave address register (SVA) not equal to serial I/O shift register 0 (SIO0) data
1 Slave address register (SVA) equal to serial I/O shift register 0 (SIO0) data
R/W CSIE0 Serial Interface Channel 0 Operation Control
0 Operation stopped
1 Operation enable
Notes 1. Bit 6 (COI) is a Read-Only bit.
2. Can be used freely as port function.
3. When 2-wire serial I/O mode is used, be sure to set WUP to 0.
4. When CSIE0 = 0, COI becomes 0.
Remark
×
: don’t care
PMxx: Port mode register
Pxx : Output latch of port