NEC 78014Y Series, User Manual

Page: 218 / 547

www.DataSheet4U.com
CHAPTER 9 8-BIT TIMER/EVENT COUNTER
218
(2) External event counter operations
The external event counter counts the number of external clock pulses to be input to the TI1/P33 pin with 2-channel
8-bit timer registers 1 and 2 (TM1 and TM2).
TM1 is incremented each time the valid edge specified with the timer clock select register 1 (TCL1) is input. When
TM1 overflows, TM2 is incremented with the overflow signal as the count clock. Either the rising or falling edge
can be selected.
When the TM1 and TM2 counted values match the values of 8-bit compare registers (CR10 and CR20), TM1
and TM2 are cleared to 0 and the interrupt request signal (INTTM2) is generated.
Figure 9-12. External Event Counter Operation Timings (with Rising Edge Specified)
Caution Even if the 16-bit timer/event counter mode is used, when the TM1 count value matches the CR10
value, interrupt request (INTTM1) is generated and the F/F of 8-bit timer/event counter output
control circuit 1 is inverted. Thus, when using 8-bit timer/event counter as 16-bit interval timer,
set the mask flag TMMK1 to 1 to disable INTTM1 acknowledgment.
When reading 16-bit timer (TMS) count value, use the 16-bit memory manipulation instruction.
TI1 Pin Input
TMS (TM1, TM2)
Count Value
0000 0001 0002 0003 0004 0005 N – 1
N
0000 0001 0002 0003
CR10, CR20
N
INTTM2