NARGESA MP3003 CNC, Instruction Book, Page: 65 / 112

ANEXO 1. SOFTWARE ESA S630 A47
The procedure can also be enabled from the AUTOMATIC page in the following manner:
- Press
- Press the button to position the back gauges axes.
- Press the down pedal to execute the bend.
- Measure the bend made in terms of bend length and angle.
If the bend is not correct:
- Press to access the correction data. If you need to make a correction to all the steps (e.g.: if all the
bends have to be at the same angle it is recommended to correct the program in general mode), enter the
data in the “Piece” column. If you need to correct the data of a section, enter the data in the “Section”
column, of if you want to correct the data relating to a bend, enter the data in the Bend column.
- Enter the correction data.
Figure 37 Correction page
Setting of the correction data
The correction data to be entered are in mm for the position of the back gauges axes, and in degrees for
the bend angle; the data entered will be added to the value contained in the program.
Example: if the bend is closed by 2° it is necessary to enter a positive correction value (+2.0°); if the bend
is open by 2° it is necessary to enter a negative correction value (-2.0°).
If the length of the bend is less than the desired length you must enter a positive value in the
Corr. X1 Field
corresponding to the difference detected; if the length of the bend is greater than the desired length you
must enter a negative value in the
Corr. X1 Field corresponding to the difference detected.
If several corrections are made to the data of the same bend, the last value entered will be added to the
previous ones.
Example: if a bend is initially closed by 3° and after the correction (+3.0°) it is open by 1°, it will be
necessary to enter 1.0° in the field for correcting the angle.
During the correction of the step, the correction data of the angles are separated per cylinder; it is therefore
possible to correct the angle of Y1 in a different manner to the angle of Y2.
In the general correction the bend angle will be corrected the same way for both cylinders.
If a correction to the pitch is made as well as a correction to the piece during the same step, the values
entered will match.