NARGESA MP3003 CNC, Instruction Book, Page: 32 / 112

ANEXO 1. SOFTWARE ESA S630 A14
The left-hand window is the drawing window.
The four right-hand windows are drawing data entry windows and respectively represent:
- The polar drawing data
- The Cartesian drawing data
- The vertex drawing data
- The arc drawing data
Drawing conventions
The punch must be drawn in an anticlockwise direction, remembering that the back-gauges are on the right
-hand side of the punch itself.
Figure 6 Punch drawing direction
Vertex entry
The tip must be defined in order to use the punch drawing. When the drawing is started, the marked line
represents one of the two sides of the tip. Proceed in the following way to define the tip:
- Enter the length “lp” , touching with a finger on the field;
- Press
[Ok];
- Enter the tip angle (ang. angle) , touching with a finger on the field;
- Press
[Ok];
- Enter the tip chamfer if the tip is flat, touching with a finger on the field (S data item, normally is 0)
- Press
[Ok];
- Enter the tip radius (R data item), touching with a finger on the field;
- Press
[Ok];
- Enter the punch load (maximum tons for meter) , touching with a finger on the field;
- Press
[Ok].
The tip will be drawn and the next length will be automatically drawn with a default length of 20 mm.