NARGESA MP3003 CNC, Instruction Book, Page: 10 / 112

INSTRUCTIONS BOOK PRESS BRAKE MP3003 CNC 10
3. MAINTENANCE
3.1. General maintenance
At the top of the tank there is the level sightglass. In the absence of oil, fill up to the mark of the peephole.
- Every 1000 hours of use, check the oil level in the tank.
- Replace oil every 4,000 hours of work.
Oil Type: SIL POWER HV-46
WARNING
Stop the machine in order to carry out the maintenance of the machine. In case of replacement of the oil,
start the engine and depress the flashing time increasing the pressure gradually until the circuit is
complete.
- Grease the boulders fixing rods and piston periodically depending on use.
- If the use is daily and continuous, grease each month.
- Grease all guide fittings monthly.
- Check the oil level of the machine.
Filling cap
Oil level sight glass
Emptying cap