NARGESA MP3003 CNC, Instruction Book, Page: 33 / 112

ANEXO 1. SOFTWARE ESA S630 A15
How to do the drawing
Supposing that the following punch must be drawn:
The cursor is in Field 1 of the data entry window of the drawn tip data:
- Enter the tip data as previously described
- Enter the length of the second side of the tip (section l1)
- Press
[ENTER]: the cursor will set to the alpha Field where the angle is entered in relation to the next
section
- Press on the display to move to the design, using own touch (touch environment)
- Press
[ENTER]: the next section will be drawn in automatic mode. The section to which the data refer will
be marked, the cursor will move to Field 1 where the length of the section is entered
- Press
[Arc]
- Enter the length corresponding to section l2 in Field 1
- Enter the depth corresponding to section p1 in Field h
- Press
[ENTER]
- Enter the length corresponding to section l3 in Field 1
- Press
[ENTER]: the cursor will move to the alpha Field where the angle is entered in relation to the next
section
- Enter value 90.0 in the
alpha field
- Press [ENTER]: the next section will be drawn in automatic mode. The section to which the data refer will
be marked, the cursor will move to Field 1 where the section length can be entered. The punch drawing will
form by continuing to alternatively enter the lengths and angles. The more the entered measurements and
angles correspond to reality, the more the drawing will be correct. Figure 7 Example of a punch to be
drawn.
Figure 7) Example of punch drow