NARGESA MP3003 CNC, Instruction Book, Page: 39 / 112

ANEXO 1. SOFTWARE ESA S630 A21
The cursor is in Field 1 of the polar drawing data entry window:
- Enter the length corresponding to the length
l1 in the field “l”, touching with a finger on the field;
- Press [Ok]: the cursor will set to the α Field where the angle is entered in relation to the next section. Now
define the first V-die of the die.
V-die entry
Comply with the following procedure:
- Press
[Insert V-die]; the data entry window will automatically switch to the V-die data where it is
necessary to:
- Enter the V-die angle (angle aC1), touching with a finger on the field;
- Press
[Ok];
- Enter the width “l” of the V-die (lC1 length), touching with a finger on the field ;
- Press
[Ok];
- Enter radius R of the V-die, touching with a finger on the field;
- Press
[Ok];
- Enter the V-die load (maximum tons for meter), touching with a finger on the field;
- Press
[Ok]; the V-die will be drawn and the next length automatically entered. The cursor will return to the
polar data entry window;
- Enter the length corresponding to section l2 in field “l”, touching with a finger on the field;
- Press
[Ok];
- Enter the value of angle a1, touching with a finger on the field;
- Press
[Ok]; the next length will be drawn in automatic mode. The length to which the data refer will be
marked, the cursor will move to the field “l”;
- Enter the length corresponding to the length l3 in the field “l”, touching with a finger on the field;
- Press
[Ok]; the cursor will move to the α field where the angle is entered in relation to the next lenght.
The second V-die must now be defined:
- Press
[Insert V-die]; the data entry window will automatically switch to the V-die data where it is
necessary to:
- Enter the V-die angle (angle aC2), touching with a finger on the field;
- Press
[Ok];
- Enter length “l” of the V-die (section lC2), touching with a finger on the field;
- Press
[Ok];
- Enter the V-die radius R, touching with a finger on the field;
- Press
[Ok];
- Enter the V-die load (maximum tons for meter), touching with a finger on the field;
- Press
[Ok]; the V-die will be drawn and the next length automatically entered. The cursor will return to the
polar data entry window;
- Enter the length corresponding to the length l4 in the field “l”, touching with a finger on the field;