NARGESA MP3003 CNC, Instruction Book, Page: 64 / 112

ANEXO 1. SOFTWARE ESA S630 A46
- In order to have a better view of the heights of the axes, it is possible to double the size of the characters
of the page.
This page is enabled by pressing
- To return to the page with single size characters press again.
Figure 36 Double size automatic numeric page
Carrying out the automatic cycle
To start an automatic cycle just press the START button; this operation enables the positioning of the
back gauges axes. At the end of the positioning of the back gauges axes press the down pedal to move
down the ram and make the bend.
Once the bend has been made, the ram will automatically return and the positioning of the back gauges
axes relating to the next bend will take place.
Once the last bend of the program has been made, the automatic cycle will start from the first bend.
First bend
This allows you to view the first bend to realize. Select [First Bend]
Execution of the sample piece
The calculations made by the numeric control are purely theoretical and due to the imperfection of the
sheet metal, it may be necessary to make corrections to the values calculated.
To simplify the correcting of the bend data of a piece there is a procedure to perform a sample piece in the
SEMI-AUTOMATIC page.
In SEMIAUTOMATIC, at the end of a bend there is no step change, instead the cycle remains on the
current bend to allow the operator to correct the bend data and then repeat the bend that has been
corrected.
It is possible to make step-by-step corrections to the angle or the length of the bend for all the bends.
The corrections entered are automatically illustrated in the program.