NARGESA MP3003 CNC, Instruction Book, Page: 34 / 112

ANEXO 1. SOFTWARE ESA S630 A16
Graphic helps
In relation to sections whose measurements may cause difficulties, the operator can use graphic helps
allowing the angle value to be varied by ± 1° and the length to be varied by ± 1mm each time. This
achieves a visual correspondence between the drawing and the real punch. To enable this feature, only
valid for settings punches:
- Press the button to access the menu
- Select the
3>> DYNAMIC
The angle value is increased by 1° by pressing the right arrow and is diminished by one degree at a time by
pressing the left arrow. The length value is increased by pressing the up arrow and decreased by pressing
the down arrow.
Drawing curved sections
As shown in the example, the drawing function can be used to draw curved sections. Press the [Arc] key
and the cursor will move to the arc data entry window.
Enter length “l2 and depth “h” of the arc and the curve corresponding to the entered data will be
automatically plotted.
Entered data correction
Incorrect entries may be made during drawing entry.
Is it possible correct these entries moving amongst the various drawn with the and buttons and
by modifying the values of the fields.
- Use the button to switch to the immediately previous entry field and then alternatively pass to a
length entry field “l” and an angle entry field “alpha”.
- The button immediately passes to the next length and, thus, always to the length entry Field “l”
- Press
[ENTER] to pass to the immediately following entry Field and to then alternatively pass to a section
entry Field (l) and an angle entry Field (alpha).
Error correction
A very frequent error (particularly if the arrows are used to enter the angles) is that of forgetting to press
[ENTER] after having entered an angle. At this point, the length of the section will be entered in the
angle entry field, thus creating an error in the drawing.
Use the key to move back to the angle entry Field and re-enter the correct value.
Saving the drawing
At the end of the drawing, press the button to save it in the internal memory. Enter the name of the
punch in the window that appears, touching with a finger on the field.
After the name has been entered, select the
[Ok] button.