NARGESA MP3003 CNC, Instruction Book, Page: 61 / 112

ANEXO 1. SOFTWARE ESA S630 A43
Simulation
In the optimisation window of the graphic program, once the solution has been accepted, it will be possible
so simulate the bending sequence obtained:
- Press the function key
[Simulate], the piece without bends will be displayed, set up and ready for realize
the first bend.
- Press the function key
[Rest/support], as many times as necessary, to select the first or second
supporting of the piece (if available), obviously the stop will only move into the supported position if there
aren’t collisions and if the limit heights of the axes permit.
- Press the function key
[Continue], the piece will be displayed with the first bend already made.
- Press the function key [Continue], the piece will be displayed with the first bend already made and in
position for the second bend.
- To stop the simulation press the function key
[Stop], to return to the previous step in the simulation press
the function key [Previous].
- Press the function key [Continue], until the end of the simulation (the function key [Simulate] will reappear)
Rest/support mode
In the optimisation window of the graphic program, once the solution has been accepted, it will be possible
realize a supported bend:
- Press the function key
[Simulate], the piece without bends will be displayed, set up and ready to realize
the first bend.
- Press the function key
[Rest/support], as many times as necessary, to select the first or second supported
position (if available) or the resting-against position of the piece, obviously the stop will only move into the
supported position if there are collisions and if the limit heights of the axes permit.
- Press the function key
[Continue], the piece will be displayed with the first bend already made.
- Press the function key [Continue], the piece will be displayed with the first bend already made and in
position for the second bend.
- Press the function key
[Rest/support], as many times as necessary, to select the first or second supported
position (if available) or the resting-against position of the piece, obviously the stop will only move into the
supported position if there are collisions and if the limit heights of the axes permit.
- To stop the simulation press the function key
[Stop], to return to the previous step in the simulation press
the function key [Previous].
- Press the function key [Continue], until the end of the simulation (the function key [Simulate] will reappear)
- The function is displayed in the numeric program at the top, on the right hand side of the type of bend.
The control automatically calculates the corrections necessary on the X and the R. The function key
[Rest/
support], in numeric mode will not work if the program is graphic. To change the rest/support mode
it is necessary to enter in the simulation page.