NARGESA MP3003 CNC, Instruction Book, Page: 30 / 112

ANEXO 1. SOFTWARE ESA S630 A12
2.1.1 How to enter a new punch
Comply with the following procedure to enter a new punch:
- Press the button ; the list of punches or list of dies will appear
- If you see the dies list press again the button.
Select the desired type of punch. The punch can either be completely drawn or three types of pre-set
punches with fixed measurements can be used. These measurements are varied in order to rescale and re
-design the punch.
The following types of pre-set punch are available:
Figure 3 Types of pre-set punch
It is advisable to use pre-set punches if the punch to be entered is similar to one of the proposed types
(taken from the catalogues), since the drawing will be less difficult.
The punch must be completely drawn if it is not within the pre-set punch categories.
Note
Remember that the punch drawing is used to make anti-collision checks for the graphically designed work
pieces, while the bending depth calculation is developed according to the punch dimension data. If there
are difficulties in completely drawing a punch, the problem can be obviated by using a type of pre-set
punch and attempting to adapt it to the real shape as much as possible by means of the pre-defined data.