NARGESA MP3003 CNC, Instruction Book, Page: 36 / 112

ANEXO 1. SOFTWARE ESA S630 A18
2.2 How to enter a new die
Comply with the following procedure to enter a new die:
- Press the button; the list of punches or list of dies will appear.
- If the list of punches appears, press button again.
- Select the required type of die. The die can be completely drawn or the pre-set die with fixed dimensions
can be used. These measurements can be varied in order to rescale and redrawn the die:
Figure 9 Available types of pre-set die
It is advisable to use pre-set dies if the die to be entered is similar to one of the proposed types (both
square and overturned T dies can be drawn), since the drawing will be less difficult.
The die must be completely drawn if it is not within the pre-set die categories, if is a die with several V-die,
if is a square V-die or a dutch folding die.
Note
Remember that the die drawing is used to make anti-collision checks for the graphically designed work
pieces, while the bending depth calculation is developed according to the die dimension data. If there are
difficulties in completely drawing a die, the problem can be obviated by using a type of pre-set die and
attempting to adapt it to the real shape as much as possible by means of the pre-defined data: