NARGESA MP3003 CNC, Instruction Book, Page: 57 / 112

ANEXO 1. SOFTWARE ESA S630 A39
Saving the drawing
At the end of the setting, press the button; a window will open in which it is necessary to enter the
name of the program.
After having entered the name, touching with a finger on the field, move onto the [Ok] button.
3.4 Automatic calculation of the bending sequence (Optional in the S630 model)
It is possible to access the automatic calculation procedure from the drawing page of the piece by following
the steps below:
- From the PIECE SETTING page after have drawing it in all its parts press
[Calculate].
Calculation window
A window will open that shows the simulation of the piece to be bent, including the lower and upper part of
the press-brake, the punch, the die, the stops and the piece before to being bent.
On the right side of the page there are three windows that respectively indicate the upsetting and the
number of rotations of the piece relating to the bending sequence found, and the criterion chosen for the
bending sequence search (Criterion).
The numeric control searches for the solution by always trying to leave the greatest part of the metal sheet
in the operator's hands (the icon that will appears will be the following: ); if you change the calculation
“Criterion” selecting
[All the solution] it is possible to search for the sequence among all the possible
solutions, even those potentially dangerous for the operator (the icon that will appears will be the
following: ).
Figure 33 Calculation page of the bending sequence
It is possible to make the calculation of the bending sequence in two modes: automatic or manual.