MS ENERGY eBike c500, Instruction Manual

Page: 377 / 424

ENG
12
Attach and adjust the handlebar
Your handlebars have two main parts:
1. The bar itself
2. The stem.
On some models, the stem can be adjusted
to tip the handlebar forward or back. If
your bar has been removed for shipping,
position the bar in the center of the stem and check, to be sure that your grips
are in the right place and the angle of the bar is comfortable. Tighten the screws
to hold the bar in place, ensuring all brake cables is clear, the suggested
torque is 13‐14Nm.
ATTENTION: Be sure to check that your handlebars are centered and tight
before riding
The stem must be inserted to the Minimum depth or lower as indicated on the
steer post to insure the safety, see the picture. Tighten the stem screw located
on the top of the handlebar stem.
Warning:
The danger of damaging the
stem‐to‐fork assembly and
the risk of injury to the rider
that
can result from
overtightening the stem
bolt or other clamping
device.
You may adjust the
handlebar stem angle by
loosening the Allen key
screw located underneath
the stem (A).
Tighten the stem,
adjustment screw securely
after positioning the stem
angle.The tightening torque between the handlebar and the frame stem should
be bigger that 18‐20Nm.
Check that the forks and the handlebars are facing forward and straight. Stand
at the front of the handlebar, vise the front wheel by your legs and hold the
Installed by
Factory
Stern Binder Bolt
Top Cap
Spacer
Steer Clamp Bolts
Handlebar
Handlebar
Stem Clamp
Bolts
Handlebar Stem Clamp
B
C