Mitsubishi NZ2GFCF-D62PD2, User Manual

Page: 269 / 304

267
APPENDICES
A
Appendix 3 Details of R
emote Buffer
Memory Addresses
Appendix 3
Details of Remote Buffer Memory Addresses
The following shows details of remote buffer memory addresses.
(1) Station-based parameter data (address: 0001
H
)
(2) Station-based parameter data (address: 0002
H
to 0003
H
)
Address
Name Description Default
CH1 CH2
0001
H
Input response time
setting
• Set the input response time of the extension input module.
• The following shows the setting range.
0005
H
Setting value
Input response
time
3
H
2ms
4
H
5ms
5
H
10ms
6
H
20ms
7
H
70ms
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
• When an extension I/O module is not installed, this setting is ignored.
Address
Name Description Default
CH1 CH2
0002
H
Output
HOLD/CLEAR
setting
• Set whether to hold or clear the output of the high-speed counter module and
the extension output module.
• The following shows the setting range.
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
0000
H
0003
H
Cyclic data update
watch time setting
• Set the time to monitor the data update interval of the cyclic transmission
(watch time).
• When the cyclic transmission remains to be stopped over the cyclic data
update watch time setting, the high-speed counter module is regarded as
disconnected. Then the output status of the high-speed counter module and
extension output module becomes HOLD or CLEAR. For details on output
HOLD/CLEAR, refer to Page 167, Section 8.17.
• The following shows the setting range.
0 to 20 (increments of 100ms) (However, when 0 is set, monitoring is not
performed.)
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 (fixed)
b15 b0 b1 b2 b3 b4 b5 b6 b7 b8 b9 b10 b11 b12 b13 b14
0: CLEAR
1: HOLD