Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 998 / 1164

SRS -
Seat Belt with Pre-tensioner
52B-44
INSTALLATION SERVICE POINTS
"
A
A
PRE-INSTALLATION INSPECTION
1. When installing a new seat belt with pre-tensioner refer
to “INSPECTION”.
Caution
Disposal of the pre-tensioner must be carried out as
stated in the procedure. (Refer to P.52B-42.)
2. Connect the battery (-) terminal.
3. Connect the MUT-II to the diagnosis connector.
Caution
Make certain that the ignition switch is OFF when
the MUT-II is connected or disconnected.
4. Turn the ignition switch to the “ON” position.
5. Conduct self-diagnosis using the MUT-II to ensure entire
SRS operates properly, except open circuit of seat belt
with pre-tensioner.
6. Turn the ignition switch to the “LOCK” position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the
battery cable before doing any further work. (Refer
to P52B-4.)
"
B
A
POST-INSTALLATION INSPECTION
1. Reconnect the negative battery terminal.
2. Turn the ignition switch to the “ON” position.
3. Does the “SRS” warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
4. If yes, SRS system is functioning properly. If no, consult
page 52B-8.
SRS warning lamp