Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 991 / 1164

SRS -
Air Bag Modules and Clock Spring
52B-37
A
D
"
FRONT PASSENGER’S SIDE AIR BAG MODULE
REMOVAL
Pry out B shown with a flat-tipped screwdriver to disengage
the 12 claws.
Caution
The removed air bag module should be stored in a clean,
dry place with the pad cover face up.
A
E
"
FRONT SEAT BACK ASSEMBLY REMOVAL
Refer to GROUP 52A - Seat.
Caution
1.
The side air bag module only can not be replaced.
Replace the front seat back assembly.
2. Store the removed front seat back assembly in a clean,
dry place with its back contacting the ground.
INSTALLATION SERVICE POINTS
"
A
A
PRE-INSTALLATION INSPECTION
1. Even if new air bag module, clock spring and front seat
back assembly are installed, it is necessary to check
before installation. (Refer to P.52B-39.)
Caution
Deploy the air bags in the specified procedures when
the air bag modules or front seat back assembly are
discarded. (Refer to P.52B-45.)
2. Connect the battery (-) terminal.
3. Connect the MUT-
II
to the diagnosis connector.
Caution
Make certain that the ignition switch is OFF when
the MUT-
II is connected or disconnected.
4. Turn the ignition switch to the “ON” position.
5. Conduct self-diagnosis using the MUT-
II
to ensure entire
SRS operates properly, except open circuit of air bag
modules.
6. Turn the ignition switch to the “LOCK” position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the
battery cable before doing any further work.
(Refer to P.52B-4.)
Section A - A
Claw
Front passenger’s
side air bag module
Claw
B
A
A
B