Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 995 / 1164

SRS - Side Impact Sensor
52B-41
SIDE IMPACT SENSOR
52400460068
Caution
1.
Disconnect the battery ( - ) terminal and wait
for 60 seconds or more before starting work.
Furthermore,
the disconnected battery
terminal should be covered with tape to
insulate it. (Refer to P.52B-4.)
2. Never attempt to disassemble or repair the
side impact sensor. If faulty, replace it.
3. Do not drop or subject the side impact
sensor to impact or vibration.
If denting, cracking, deformation, or rust are
discovered in the side impact sensor,
replace it with a new side impact sensor.
Discard the old one.
4. After deployment of an air bag, replace the
side impact sensor with a new one.
REMOVAL AND INSTALLATION
Pre-removal Operation
Turn the ignition key to the “LOCK” position.
2
1
5 Nm
Center pillar
Front of
vehicle
Removal steps
"
C
A D Post-installation inspection
D Negative (-) battery cable connection
D Seat belt with pre-tensioner (Refer to
P.52B-43.)
1. Front seat belt cover
"
B
A 2. Side impact sensor
"
A
A D Pre-installation inspection
NOTE
The illustration above shows the side impact sensor
(R.H.). The position of the side impact sensor (L.H.) is
symmetrical to this.