Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 640 / 1164

FRONT SUSPENSION -
Stabilizer Bar
33A-16
3.Use the special tool to remove the stabilizer bar bracket
mounting bolt.
4. Remove the stabilizer bar bracket.
5. Position a new bushing so that its cut is as shown.
6. Position the stabilizer at the left side of the vehicle so
that its identification mark is as shown, and then tighten
the stabilizer bar bracket mounting bolts.
7. Install the stay, front member, side cover mounting clip
in that order.
STABILIZER LINK BALL JOINT DUST COVER
REPLACEMENT
33201020015
Only when the dust cover is damaged accidentally during
service work, replace the dust cover as follows:
1. Remove the clip ring and the dust cover.
2. Apply multipurpose grease to the inside of the dust cover.
3. Use plastic tape on the stabilizer link threads as shown
in the illustration, and then install the dust cover to the
stabilizer link.
4. Secure the dust cover by the clip ring.
5. Check the dust cover for cracks or damage by pushing
it with finger.
Stabilizer bar bracket
Bushing
MB991164
Front side of
the vehicle
Bushing
Approx. 20 mm
Clip ring