Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 98 / 1164

ENGINE <4G9> -
Crankshaft Oil Seal
11B-24
REMOVAL SERVICE POINT
A
A
"
PLATE <M/T>/ADAPTOR PLATE/FLYWHEEL
<M/T>/DRIVE PLATE <A/T> REMOVAL
Use the special tool to secure the flywheel or drive plate,
and remove the bolts.
INSTALLATION SERVICE POINTS
"
A
A
CRANKSHAFT REAR OIL SEAL INSTALLATION
1. Apply a small mount of engine oil to the entire
circumference of the oil seal lip.
2. Install the oil seal by tapping it as far as the chamfered
position of the oil seal case as shown in the illustration.
"
B
A
DRIVE PLATE <A/T>/FLYWHEEL <M/T>/ADAPTOR
PLATE/PLATE <M/T> INSTALLATION
1. Clean off all sealant, oil and other substances which are
adhering to the threaded bolts, crankshaft thread holes
and the flywheel or drive plate.
2. Apply oil to the bearing surface of the flywheel or drive
plate bolts.
3. Apply oil to the crankshaft thread holes.
4. Apply sealant to the threaded mounting holes.
Specified sealant: 3M Stud locking 4170 or equivalent
5. Use the special tool to hold the flywheel or drive plate
in the same manner as removal, and install the bolt.
"
C
A
CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Apply a small amount of engine oil to the entire
circumference of the oil seal lip.
2. Tap the oil seal unit it is flush with the oil seal case.
MD998781
Crankshaft
rear oil seal
MD990938
MD998776
Crankshaft
Crankshaft
MD998717
MD998717
Oil seal