Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 100 / 1164

ENGINE <4G9> -
Cylinder Head Gasket
11B-26
Removal steps
1. Injector harness connector
2. Front exhaust pipe connection
3. Exhaust manifold bracket
4. Power steering oil pump bracket
stay
A
A
" 5. Power steering oil pump and
bracket assembly
6. Idler pulley
7. Timing belt rear cover
8. Engine oil level gauge assembly
9. Rocker cover
A
B
" "
B
A 10. Cylinder head bolt
11. Cylinder head assembly
"
A
A 12. Cylinder head gasket
REMOVAL SERVICE POINTS
A
A
"
POWER STEERING OIL PUMP AND BRACKET
ASSEMBLY REMOVAL
Remove the power steering oil pump and bracket assembly
from the engine with the hose attached.
NOTE
Place the removed power steering oil pump and bracket
assembly in a place where it will not be a hindrance when
removing and installing the cylinder head assembly, and tie
it with a cord.
A
B
"
CYLINDER HEAD BOLT REMOVAL
Use the special tool to loosen the bolts in two or three steps
in the order of the numbers shown in the illustration, and
then remove the bolts.
INSTALLATION SERVICE POINTS
"
A
A
CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting
surface.
2. Install so that the shapes of the cylinder head holes match
the shapes of the respective cylinder head gasket holes.
Intake side Front of engine
Exhaust side
MB991653
3 5 10 8 2
1 7 9 6 4