Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 993 / 1164

SRS -
Air Bag Modules and Clock Spring
52B-39
"
E
A
POST-INSTALLATION INSPECTION
1. Turn the steering wheel right and left lightly to see its
smooth operation, being free from abnormal noise.
(Driver’s side air bag module, clock spring)
2. Reconnect the negative battery terminal.
3. Turn the ignition switch to the “ON” position.
4. Does the “SRS” warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
5. If yes, SRS system is functioning properly.
If no, consult page 52B-8.
INSPECTION
52400250412
DRIVER’S SIDE AIR BAG MODULE/FRONT
PASSENGER’S SIDE AIR BAG MODULE CHECK
If any improper part is found during the following inspection,
replace the air bag module with a new one.
Dispose the old one according to the specified procedure.
(Refer to P.52B-45.)
Caution
Never attempt to measure the circuit resistance of the
air bag modules (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester,
accidental air bags deployment will result in serious
personal injury.
1. Check cover for dents, cracks or deformation.
2. Check connectors for damage, terminals for deformation,
and harness for binds.
3. Check air bag inflator case for dents, cracks or
deformation.
4. Install the air bag module (driver’s side) to steering wheel
to check fit or alignment with the wheel.
5. Install the air bag module (front passenger’s side) to the
instrument panel and crossmember and check fit and
alignment.
Caution
If dents, cracks, deformation, or rust are discovered
in the air bag module, replace it with a new one.
Dispose of the old one according to the specified
procedure. (Refer to P.52B-45.)
SRS warning lamp
Connector
<Driver’s side>
<Front passenger’s side>
Inflator case
Connector
Inflator case