Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 1011 / 1164

SRS -
Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-57
Caution
1) Slack the deployment wires below the wheel.
If deployment wires are tight, the reaction
when the seat belt pre-tensioner deploys could
damage the adaptor harness.
2) The connector of the SRS air bag adapter
harness should be placed so that it is not
clamped by the tyres during deployment or
operation.
3) Pull the seat belt out the outside of the tyre,
and then place one tyre without a wheel on
top of the existing tyre.
(5) Place three old tyres without wheels on top of the
tyre secured to the seat belt pre-tensioner.
(6) Disconnect the deployment wires as far from the seat
belt pre-tensioner as possible and connect the wires
to the terminals of the battery removed from the
vehicle, and deploy.
Caution
1) Before the deployment, be sure that no one
is near the seat belt pre-tensioner.
2) The deployment of the seat belt pre-tensioner
makes itself very hot. Before handling the seat
belt pre-tensioner, wait more than 30 minutes
for cooling.
3) If the seat belt pre-tensioner fails to deploy
when the procedures above are followed, do
not go near the seat belt pre-tensioner. Contact
your local distributor.
(7) After deployment, dispose of seat belt pre-tensioner
according to the Deployed Air Bag Module and Seat
Belt Pre-tensioner Disposal Procedures. (Refer to
P.52B-58.)
Tyre without
wheels
Tyres without wheels
Deployment wires
Deployment wires