Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 561 / 1164

FRONT AXLE -
Drive Shaft
26-17
REASSEMBLY SERVICE POINTS
"
A
A
DYNAMIC DAMPER/DAMPER BAND/T.J. BOOT
INSTALLATION
1. Install the dynamic damper in the position shown in the
illustration.
Items A (large) B (small)
SPACE RUNNER L.H. - 215 mm
R.H. 395 mm -
SPACE WAGON L.H. - 215 mm
R.H. 405 mm 585 mm
2. Secure the damper bands.
Caution
There should be no grease adhered to the rubber
part of the dynamic damper.
3. Wrap plastic tape around the shaft spline, and then install
the T.J. boot band (small) and T.J. boot.
"
B
A
SPIDER ASSEMBLY/T.J. CASE INSTALLATION
1. Apply the specified grease furnished in the repair kit to
the spider assembly between the spider axle and the
roller.
Specified grease: Repair kit grease
Caution
(1) The drive shaft joint uses special grease. Do not
mix old and new or different types of grease.
(2) If the spider assembly has been cleaned, take
special care to apply the specified grease.
2. Install the spider assembly to the shaft from the direction
of the spline bevelled section.
3. After applying the specified grease to the T.J. case, insert
the drive shaft and apply grease one more time.
Specified grease: Repair kit grease
Amount to use:
<SPACE RUNNER> 110 g
<SPACE WAGON - 2WD> 140 g
<SPACE WAGON - 4WD> 105 g
NOTE
The grease in the repair kit should be divided in half
for use, respectively, at the joint and inside the boot.
Caution
The drive shaft joint uses special grease. Do not mix
old and new or different types of grease.
B
A
Bevelled
section