Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 816 / 1164

BODY -
Door
42-44
REMOVAL SERVICE POINTS
A
A
"
DOOR CENTER SASH REMOVAL
1. Remove the door outer opening weatherstrip from the
door center sash only.
2. Remove the door center sash mounting screws, and then
remove the door center sash from the door panel.
INSTALLATION SERVICE POINTS
"
A
A
POWER WINDOW MOTOR/WINDOW REGULATOR
ASSEMBLY INSTALLATION
POWER WINDOW MOTOR AND WINDOW REGULATOR
ASSEMBLY INSTALLATION PROCEDURE
1. Connect the power window motor to the body-side harness
connector, and then turn on the ignition switch.
2. Continue to pull the power window switch until the power
window motor stops.
NOTE
Power window motor stops automatically and the limit
switch incorporated in the power window motor will be
reset.
Caution
Do not operate the power window motor until the glass
installation is finished.
3. Turn off the ignition switch, and then remove the power
window motor from the body-side harness connector.
4. Align the power window motor drive shaft and the square
hole in the drum by the following procedure, while using
the guide and the opening in the motor housing as a
reference for the installation position.
(1) Align the square hole with the drive shaft by sliding
the glass bracket (glass mounting section) or by
turning the drum using a ratchet wrench (with a socket
diameter of 12.7 mm).
Door outer
opening
weatherstrip
Door center sash
Drive shaft
Drum
Guide
Square hole
Guide
Rachet wrench
Glass bracket