Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 623 / 1164

POWER PLANT MOUNT -
Frontmember
32-7
REMOVAL SERVICE POINT
A
A
"
STEERING GEAR AND LINKAGE MOUNTING
BOLT REMOVAL
Use a wire to fix the steering gear box on the vehicle before
removing the steering gear and linkage mounting bolts.
A
B
"
FRONTMEMBER MOUNTING BOLT REMOVAL
1. Use a wire to fix the radiator on the vehicle before removing
the frontmember.
2. Support the frontmember with a garage jack and a wooden
board, and remove the frontmember mounting bolts.
INSTALLATION SERVICE POINT
"
A
A
STABILIZER BAR INSTALLATION
1. Install the bushing so that its cutting faces the direction
shown.
2. Place the stabilizer bar identification mark at the left of
the vehicle and position it as shown in the illustration.
Tighten the stabilizer bar bracket mounting bolts.
"
B
A
LOWER ARM ASSEMBLY INSTALLATION
1. Install the lower arm assembly to the knuckle.
Caution
Be careful that the ball joint stud does not project
more than 4 mm from the knuckle (A shown).
2. Replace the dust cover if grease spouted out due to
the knuckle too much pressed in.
3. Check that no clearance is present between the knuckle
and dust cover.
Wooden
board
Transmission jack
Front of vehicle
Bushing
Approx. 20 mm
Knuckle
Lower arm
assembly
A