Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 553 / 1164

FRONT AXLE -
Front Hub Assembly
26-9
INSTALLATION SERVICE POINT
"
A
A
DRIVE SHAFT NUT INSTALLATION
1. Install the drive shaft washer in the specified direction.
2. Using the special tool, tighten the drive shaft nut.
Caution
Before securely tightening the drive shaft nuts, make
sure there is no load on the wheel bearings. Otherwise
the wheel bearing will be damaged.
3. If the position of the split pin holes does not match, tighten
the nut up to 255 Nm in maximum.
4. Install the split pin in the first matching holes and bend
it securely.
INSPECTION
26100180140
WHEEL BEARING ROTATION STARTING TORQUE
CHECK
1. Install the special tool to the front hub assembly and
tighten the nut to the specified torque.
2. Use the special tool to measure the wheel bearing starting
torque.
Limit: 1.0 Nm or less
3. The wheel bearing starting torque should be within the
limit value range, and there should be no engagement
or feeling of roughness.
WHEEL BEARING AXIAL PLAY CHECK
26100110125
1. Install the special tool to the front hub assembly and
tighten the nut to the specified torque 196 - 255 Nm.
2. Measure the play in the hub axial direction.
Limit: 0.05 mm
3. If the limit value of hub axial play cannot be obtained,
replace the front hub assembly.
MB990767
196 - 255 Nm
Washer
MB991000
(MB990998)
MB990326
196 - 255 Nm
MB991017
Wood block
MB991017
Wood block
Wood block