Mitsubishi MOTORS Space Runner 1998, Workshop Manual

Page: 817 / 1164

BODY -
Door
42-45
(2) Turn the drum to position the glass bracket as shown
in the illustration. Support the drum and the guide with
your hand while turning the drum, otherwise the wires
may pull out of the drum.
(3) If the wires pull out of the drum, re-insert them by
following the drum and regulator wire installation
procedure.
5. Align the guide and the opening of the motor housing,
and slide the guide into the motor housing while holding
the guide and drum.
6. Install the metal cover securely to the housing.
Caution
Make sure that the metal cover is installed securely
and does not move, in order to stop the drum from
vibrating. If the drum vibrates, the glass may not slide
up and down smoothly, or it may fall down.
DRUM AND REGULATOR WIRE INSTALLATION
PROCEDURE
1. Place the drum, guide and regulator on a work bench
as shown in the illustration.
(1) Place the drum so that the square hole is facing
upward.
(2) Place the guide so that the slits are facing upward.
(3) Place the regulator so that the glass bracket is facing
downward. Position the glass bracket so that glass
is in the fully-open position.
2. Pass the springs over the wires, and then install the
lowering wire to the guide first, followed by the lifting
wire. (The lifting wire should be on top of the lowering
wire.)
Approx. 85 mm
Glass
bracket
Mounting
screw
Metal cover
Spring A
Square hole
Spring B
Drum
Guide
Lifting
wire
Slit
Lower-
ing wire
Lowering wire
Spring
Slit
Lifting wire
Guide