7 FUNCTIONS
7.10 Slave Module Parameter Read/Write
69
7
7.10
Slave Module Parameter Read/Write
This function reads/writes individual or all parameter information of a slave module or the AnyWireASLINK by using the
program.
Use this function to check or change parameter information of a slave module.
For details on the parameter information to be read/written, refer to the following.
Page 145 Parameter access setting
Page 146 Parameter access target module ID specification
Parameter reading and writing methods
The following table lists the parameter read/write methods.
The following shows the readable/writable parameters.
: Possible,
: Impossible
*1 The parameters that can be set differ depending on the slave module. For details, check the manual of the slave module used
(manufactured by Anywire Corporation).
Parameter access does not affect the AnyWireASLINK transmission cycle time.
Automatic update
The status details and sensing level of the AnyWireASLINK parameters are automatically updated, so no special operation is
required. To check the parameter information, refer to the corresponding remote buffer memory.
Type
Description
Automatic update
The status details and the sensing level of all slave modules are read at regular
intervals. (Setting values are excluded.)
Parameter access
Parameter
individual access
Parameter individual read
Read the parameters of any slave module.
Parameter individual write
Write the parameters of any slave module.
Parameter batch
access
Parameter batch read
Read the parameters of all slave modules.
Parameter batch write
Write the parameters of all slave modules.
Parameter name
Parameter reading/writing method
Automatic
update
Parameter access
Parameter
individual read
Parameter
individual
write
Parameter
batch read
Parameter
batch write
Device parameter
AnyWireASLINK
parameter
Module ID
Status details
Sensing level
Word point pattern
Bit point pattern
Model number
Device version
Summary of Contents for AnyWire ASLINK
