Mitsubishi Electric AnyWire ASLINK, User Manual

Page: 27 / 200

5 INSTALLATION AND WIRING
5.1 Setting Switch
25
5
MODE switch setting
Use the MODE switch located on the front of the NZ2AW1GNAL to set the number of transmission points and the operation
mode of AnyWireASLINK.
The MODE switch setting is enabled when the NZ2AW1GNAL is in the power-on state, so set it while the power is off.
When operating the MODE switch, use a flathead screwdriver with a tip width of 0.8mm or less.
Setting method
Use MODE switch 1 to MODE switch 12 to set each function.
All switch positions are set to off when the product is shipped.
Switch name Setting item Setting
MODE switch 1 Operation mode Turn it off during normal operation.
Turn it on when performing unit tests. (

Page 113 Unit Test)
MODE switch 2 Number of AnyWireASLINK
transmission points setting Turn it on when using MODE switch 3 to MODE switch 8 to set the number of
points.
Turn it off when setting the number of points using an engineering tool.
MODE switch 3 to MODE switch 5 Number of AnyWireASLINK bit
points Set the number of AnyWireASLINK bit points. (

Page 26 Number of
AnyWireASLINK bit points setting)
MODE switch 6 to MODE switch 8 Number of AnyWireASLINK
word points Set the number of AnyWireASLINK word points. (

Page 26 Number of
AnyWireASLINK word points setting)
MODE switch 9 to MODE switch 12 Use prohibited Fix them to off.