5
Status display section 3
Displays error status
SQ. ERR 0
: Lights when weighing is forcibly interrupted by temporary stop
input
SQ. ERR 1
: Lights when the SAFETY CHECK condition is not satisied
SQ. ERR 2
: Lights when the load value is insuicient, even if post-batching is
executed
SQ. ERR 3
: Lights when magnitude correlation of the comparison value is
contradictory
SQ. ERR 4
: When the inlow time exceeds the time limit
SQ. ERR 5
: When the discharge time exceeds the time limit
SQ. ERR 6
: Lights when gross weight is less than the inal value during
discharge control
SQ. ERR 7
: Lights when initial net weight > inal value – ine low
SQ. ERR 8
: Lights if the nozzle makes contact with the container during
nozzle control
SQ. ERR 9
: Lights if there is no container on the load cell when weighing with
[START ABOVE ZERO BAND](start from zero band or above) set
to efective
SQ. ERR 10
: Lights if a weighing signal is input while the gate is manually
operated
SQ. ERR 11
: Lights if the input weighing signal excludes the original gate po-
sition
SV. ERR EMG
: Lights when the [EMG] switch is pressed
SV. ERR ALM
: Lights when an alarm signal is output from the servo ampliier
SV. ERR RD
: Lights when a ready signal is not output from the servo ampliier
SV. ERR + LMT : Lights if the gate exceeds the OPEN side limit position
SV. ERR - LMT : Lights if the gate exceeds the CLOSE side limit position
SV. ERR SLMT : Lights if the gate exceeds the software limit position
SV. ERR ORG
: Lights when the original point cannot be detected by the original
point detection
Note:
Select [ERR. RESET] on the left of the screen to release the error and the servo er-
ror.
6 Brand information display section
Displays current brand number, brand name, accumulation value and accumulation
times
7
[ZERO]
Saves the current load display as [zero point] and sets the display value to [0]
8
[MENU]
Switches from the weighing screen to the menu screen
Weight Controller CSD-918
3 Product overview
EN-20
Minebea Intec
Summary of Contents for CSD-918 Series
Page 239: ......
